PlattenPlatte® denotes our shape-stable, aging- and weather-resistant rigid plate stilt bearings. The raw material polyethylene used contains no plasticizers. This ensures absolute compatibility with other building materials such as bitumen, PVC, PIB, elastomers and more.

Compensation of unevenness is carried out by balancing discs/ shim washers AS155/1 and AS15/3.

Unevenness of the terrace covering such. for natural stone slabs and the substrate as a slope compensation and fine adjustment are compensated by the shim washers/ balancing discs  AS15/3 or 155/1 as accessories. These are also divisible. For example, they can be placed on or between pedestals. Due to the joint spacers positioned on the pedestal, fixation is guaranteed at the same time.

The rigid pedestals PP155/15 and PP155/45 are: 

• Dynamic and impact noise-insulating
• Stackable 
• Can be spilt and installed as a three-quarter, half or quarter pedestal (e.g. installation on borders)
• Features plug-attach detail at both ends (inverted-configuration installation).

Material: 
PE (polyethylene)

Durabilty: 
dimensionally stable, non-aging and weatherproof

Compatibilty: 
no plasticisers whatsoever, full compatibility with all other building materials, e.g. bitumen, PVC, PIB, ECB, elastomers etc.

Height Adjustment: 
PP155/15 starting at 15 mm and PP155/45 starting at 45 mm

Levelling: 
Unevenness and gradients can be corrected using shim washers.

Combiation: 
With all products of our pedestals, shim washers, p.e.

> Combination options 

• Pedestal Under- and Top-Plate:
  Ø 155 mm 
• Pressure Support of Under- und Top-Plate:
  120 cm² contact area of pedestal (with preassure plate DA200/3 up to 314 cm²)
• Pedestal height:
  PP155/15 = 15 mm
  PP155/45 = 45 mm
• Spacer details:
  Length = 15mm / Width = 4mm (cross-shaped spacer) /  Height = 15 mm
  65 mm clearance between spacers (p.ex. fixation of construction beams)
• Temperature resitant
  Heat: constantly +90°C
  Cold: -50°C
• Packing:
  PP155/15: 250 pcs.
  PP155/45: 80 pcs.

> Information on Material Testing

Applications of our pedestals: 

• Plates/Tiles:
  ceramic tiles, stone, marble, granite, concrete, etc.
• Timber:
  Kantholz, Holzfliesen, Holzplatten etc.
• Plastic:
  e.g. WPC 
• Grids:
  drain systems, gratings etc. 
• Temporary installations:
  e.g. dancefoors, water features, booths, industrial floors, dooble floors, etc.

> Further Accessories e.g. Shim Washers
> Further Informations to Pedestal Applications

Specific installation instructions:

• Four plates or gratings each share a plate bearing.
• In the case of wood flooring, the load-bearing construction is placed on the stilt bearings.
• The bearings can be stacked and brought together with the balancing discs to the desired height and inclination.
• Half or quarter bearings are used at the edge and corners.
• Gaps remain open and water can thus run off underneath the paving.
• Every height is reached by simply non-slip stacking.
• Pre-determined breaking points make it easier for you to halve and quarter slab supports/pedestals. As a result there is no waste, since each subunit is reusable. Simple, non-slip stacking enables you to achieve any height that you require.
• Cost savings compared with conventional installation methods are approx. 35%.

> Further installation informations